Analog Option Card Setup Tips

Re: Analog Option Card Setup Tips

Postby gseadmin » Wed Apr 08, 2009 6:56 am

60 Series Analog Option Card Setup Tips

1. Enable analog card: Make sure analog card is enabled. P170 must be set for "enabled" before calibration values can be entered.
2. Jumper is set correctly: A single jumper on the analog output PC board (E1) selects whether the card will be addressed as analog output 1, 2, 3, 4, 5, 6, 7, or 8.
3. Calibration values to enter: P61200-P61207 to be calibrated with the main board.

Go into Setup mode to enter the values.

Return to 60 Series



cron