gse-inc.com
GSE Knowledge Base
460/465 Keypad Configuration
2 posts • Page 1 of 1
460/465 Keypad Configuration
by gseadmin » Wed Apr 08, 2009 7:00 am
How do I configure my 460 or 465 keypad?
Re: 460/465 Keypad Configuration
by gseadmin » Wed Apr 08, 2009 7:01 am
460 Keypad
If the keypad does not operate correctly at power-up, configure the keypad as follows:
1. Power down.
2. Hold down the [ENTER] key.
3. Power up.
4. Continue holding the key until "M460 Keypd" is displayed, then release.
465 Keypad
If the keypad does not operate correctly at power-up, configure the keypad as follows:
1. Power down.
2. Hold down the [SCALE SELECT] + [F1] + [SELECT] keys.
3. Power up.
4. Continue holding the keys until "M465 Keypd" is displayed, then release.
* Use these keys for firmware dated after September 28th, 2001. Previously the [ZERO] + [SCALE SELECT] + [F1] keys were used to configure the keypad at power-up.
If the keypad does not operate correctly at power-up, configure the keypad as follows:
1. Power down.
2. Hold down the [ENTER] key.
3. Power up.
4. Continue holding the key until "M460 Keypd" is displayed, then release.
465 Keypad
If the keypad does not operate correctly at power-up, configure the keypad as follows:
1. Power down.
2. Hold down the [SCALE SELECT] + [F1] + [SELECT] keys.
3. Power up.
4. Continue holding the keys until "M465 Keypd" is displayed, then release.
* Use these keys for firmware dated after September 28th, 2001. Previously the [ZERO] + [SCALE SELECT] + [F1] keys were used to configure the keypad at power-up.
2 posts • Page 1 of 1