350/355 Displaying "R-dsp"

350/355 Displaying "R-dsp"

Postby gseadmin » Tue Apr 07, 2009 1:48 pm

Why is the 350/355 displaying "R-dsp"? How can this be fixed?

Re: 350/355 Displaying "R-dsp"

Postby gseadmin » Tue Apr 07, 2009 1:49 pm

The 350/355 indicator showing "R-dsp" means the indicator is set to remote display mode. Parameter 260 is set to "R-dsp" and will show this until the 350/355 is hooked to another indicator to display weight.

The Fix

Follow the following steps to get the indicator out of remote display mode.

Model 350/350IS:
1. Enter Setup Mode:
* Press [ZERO] + [SELECT] simultaneously. When prompted Enter Code, key in ONE-by-ONE [SELECT], [ZERO], [PRINT], [UNITS], [TARE].
2. The indicator will display Allow Mods.
3. Go to Parameter 260:
* Press [PRINT] until a 2 is displayed. Press [UNITS] to move over a space. Press [PRINT] until a 6 is displayed. Press [UNITS] to move over a space. Press [PRINT] until a 0 is displayed, and then press [SELECT].
4. The indicator will go to Parameter 260 and say R-dsp.
* Press [TARE] to toggle until the display reads P260.00. The indicator will display 350.
5. From here setup any necessary parameters and exit.
* Press [ZERO], [ZERO], [TARE], [TARE].

Model 355/355IS:
1. Enter Setup Mode:
* Press 100 [SELECT] 23640 [ENTER].
2. The indicator will display Allow Mods.
3. Go to Parameter 260:
* Press 260 [SELECT].
4. The indicator will go to Parameter 260 and say R-dsp.
* Press [ENTER] to toggle until the display reads P260.00. The indicator will display 355.
5. From here setup any necessary parameters and exit.
* Press [ZERO], [CLEAR], [ENTER], [ENTER].


Return to 350 Series



cron